Blackmagic Design Web Presenter Manuel D'installation Et D'utilisation page 201

Stopping stream
The stream is stopped by providing a Stream State block with stop action.
STREAM STATE: ↵
Action: Stop ↵
↵
ACK
↵
↵
STREAM STATE:
↵
Status: Idle
↵
↵
Audio Settings Block
The Audio Settings block contains the audio configuration for the connected Web Presenter.
Block syntax
This example shows the output for a connected Web Presenter. The stream settings prefixed
with Current show the active audio settings and are writable. The stream settings prefixed by
Available show the available audio settings for the device or platform and are read-only.
AUDIO SETTINGS:
↵
Current Monitor Out Audio Source: Auto
Available Monitor Out Audio Sources: Auto, SDI In, Remote Source
↵
Parameters
Key Read/Write
Current Monitor Out
Read/Write
Audio Source
Available Monitor Out
Read only
Audio Sources
Changing Audio Settings
The audio settings can be changed by providing a audio settings block. The following is an
example of setting the monitor output audio source to remote.
AUDIO SETTINGS: ↵
Current Monitor Out Audio Source: Remote Source ↵
↵
ACK
↵
↵
AUDIO SETTINGS:
↵
Current Monitor Out Audio Source: Remote Source
↵
↵
Description
The current audio source on the monitor
output
The available audio sources that can be
routed to the monitor output
↵
Informationen für Entwickler (Englisch)
↵
Valid Values
Refer to the audio sources from
the Available Monitor Out Audio
Sources field
Comma separated list of audio
sources
201