Publicité
Technical Features:
• Built-in electronic circuit for operation with a conventional
DC power pack (max. ±12 volts), Trix Systems, Trix Selectrix or
NMRA DCC digital systems.
• Automatic system recognition between digital and analog
operation.
• No automatic system recognition between Selectrix (SX) and
DCC.
• Headlights for the locomotive change over with the direction
of travel. They can be turned on and off in digital operation.
The necessary maintenance that will comes due with normal
operation is described below. Please see your authorized Trix
dealer for repairs or spare parts.
Safety Warnings
• The feeder track must be equipped to prevent interference with radio
and television reception, when the locomotive is to be run in conventio-
nal operation. The 611 655 interference suppression set is to be used for
this purpose. The interference suppression set is not suitable for digital
operation.
• This locomotive is to be used only with an operating system
designed for it.
• Pay close attention to the safety warnings in the instructions
for your operating system.
Notes on digital operation:
• This locomotive comes from the factory programmed for the
digital address "01" (Selectrix) / "03" (DCC). Number of speed
levels that have been set: 28 (DCC) and 31 (Selectrix).
6
All manuals and user guides at all-guides.com
• The first time the locomotive is used in a digital system (Selec-
• Information about DCC Operation:
• Function:
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and/or
damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and/or damage arising, is
borne by the person and/or company responsible for the installation and/or
conversion, or by the customer.
*
trix or DCC), the decoder must be set for this digital system. To
do this, the decoder must be programmed once in this digital
system.
The setting done at the factory does not permit operation
with opposite polarity DC power in the braking block. If you
want this characteristic, you must do without conventional DC
power operation (CV29 / Bit 2 = 0).
F0
Headlights
F1
Smoke generator
F2
Locomotive operating sounds
F3
Sound effect: long whistle blast
F5
Sound effect: Air pump *
F6
Glow from firebox
F8
Sound effect: Short whistle blast
F9
Sound effect: Blowing off steam
F10
Sound effect: Coal being shoveled
F11
Sound effect: Rocker grate
only in conjunction with operating sounds, F2
Publicité
