Casada HILTON II Mode D'emploi page 12

Assembly
I. OPENING THE PACKAGING AND REMOVING THE ACCESSORIES
Foam
upper carton
1. Open the packaging adhesive tape of the outer packaging of the massage chair and lift the outer packag-
ing upwards.
2. First remove the upper box (side part) and then the foam on both sides of the massage chair.
3. Remove the accessory packaging.
4. Scope of delivery in the accessory packaging: operating instructions, power cable, Philips screwdriver,
remote control, 2 side parts, 2 shoulder airbags, Allen key, screws.
II. INSTALLING SIDE PARTS
Air hose connections
Fastening rails
Insert side parts into
the rails
1. Open the box with the side parts and remove them.
2. Firstly, connect the air hose that comes out of the side part with the air hose that comes out laterally
from the seat part. Ensure that both ends of the hoses are fully inserted into the connector. Connect the
other side part in the same way.
3. Position the side part with the two openings on the underside over the two fixing rails and insert the side
part into the rails. On the inside of the side part you will find two small holes with a zipper on each side.
You can use these to secure the side parts with the screws and the Allen key which are included in the
delivery.
TIP: Please pay attention when you assemble the screws, each side part needs to flush with the locking
device.
22
All manuals and user guides at all-guides.com
Locking screw
location
Assembly
III. ASSEMBLING THE SHOULDER AIRBAGS
Positioning screw Positioning screw
hole
Philips
screwdriver
1. Hold in your hand the lateral shoulder air bag which is secured both to the right and left of the
backrest via the side parts. To do this, open the zipper of the part completely. On the reverse side
of the shoulder air bag there are two positioning screws. Insert the shoulder air bag into the two
holes provided which are visible on the rear side.
2. Secure the shoulder airbag with three Philips screws.
(Screws and selvedge motion are included in the delivery)
3. Connect the air hose of the side air bag with the air hose that comes out of the backrest.
4. Check whether the side air bag is securely installed and that the air hoses are properly connected.
Then close the zip.
5. Do the same on the other side.
IV. INSPECTING THE ENTIRE MASSAGE CHAIR AND STRAIGHTENING
OUT THE COVER
V. SETTING UP THE MASSAGE CHAIR
1. Remove the entire massage chair from the base packaging and place it in a
5 – 10 cm
suitable position.
2. When setting up the massage chair, you need to keep a distance of 5-10
cm from the backrest to the wall and 50 cm from the front, so that the
backrest and footrest can be freely tilted.
VI. MOVING THE MASSAGE CHAIR
1. Hold the backrest with both hands as shown on the left and tilt the mas-
sage chair about 45° rearwards. Slide the massage chair carefully backwards
or forwards on the castors until it is secured in a suitable position.
Note:
Do not move the massage chair if there is a person sitting on it.
•
Refrain from moving the massage chair. If you move it, it may pos-
•
sibly damage the floor.
Hold on to the massage chair firmly to prevent it from falling
•
down.
VII. MUSICFUNCTION (SOUND SYSTEM)
To be able to listen to your favourite music, put the jack cable that is inte-
•
grated in your massage chair, into your music device.
Philips
screw
Airhose for the
Done
airbag area
23