Publicité
Les langues disponibles
Les langues disponibles
Important Safety Information
Read all safety information before
operating the equipment. Save these
instructions.
Indicates a hazardous situation which,
if not avoided, could result in death or
serious injury.
To reduce the risks of fire or explosion,
electrical shock and the injury to
persons, read and understand all
instructions included in this manual. Be
familiar with the controls and proper
usage of the equipment.
Grounding Instructions
This product must be grounded. In the event of an
electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for
the electric current. This product is equipped with a
cord having a grounding wire with an appropriate
grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
WaRnInG - Improper installation of
the grounding plug can result in a risk
of electric shock.
If repair or replacement of the cord or plug is
necessary, do not connect the green grounding wire
to either flat blade terminal. The wire with insulation
having a green outer surface with or without yellow
stripes is the grounding wire and must be connected
to the grounding pin.
Check with a qualified electrician or serviceman
if the grounding instructions are not completely
understood, or if you are in doubt as to whether the
product is properly grounded. Do not modify the
plug provided. If the plug will not fit the outlet, have
the proper outlet installed by a qualified electrician.
This product is for use on a nominal 120 volt
circuit and has a grounding plug that looks like
the plug illustrated below. Make sure that the
product is connected to an outlet having the same
configuration as the plug. No adapter should be
used with this product.
Grounded Outlet
Grounding Pin
Cover for grounded outlet box
English
2
All manuals and user guides at all-guides.com
1. Do not spray flammable or combustible
2. For use with only water-based or mineral
3. Verify that all containers and collection systems
4. Connect to a grounded outlet and use
5. Keep spray area well ventilated. Keep a good
6. Do not smoke in the spray area.
7. Do not operate light switches, engines, or
8. Keep area clean and free of paint or solvent
9. Know the contents of the paint and solvents
10. Fire extinguisher equipment shall be present
WaRnInG - To reduce the risk
of fire or explosion:
materials near an open flame, pilot lights
or sources of ignition such as hot objects,
cigarettes, motors, electrical equipment and
electrical appliances. Avoid creating sparks
from connecting and disconnecting power
cords.
spirit-type materials with a minimum flash point
of 100ºF (38ºC) — Do not spray or clean with
liquids having a flash point of less than 100ºF
(38ºC). Flash point is the temperature at which
a fluid can produce enough vapor to ignite.
are grounded to prevent static discharge.
grounded extension cords (electric models
only). Do not use a 3 to 2 adapter.
supply of fresh air moving through the area
to keep the air within the spray area free from
accumulation of flammable vapors. Keep pump
assembly in well ventilated area. Do not spray
pump assembly.
similar spark producing products in the spray
area.
containers, rags, and other flammable materials.
being sprayed. Read all Material Safety Data
Sheets (MSDS) and container labels provided
with the paints and solvents. Follow the paint
and solvent manufacture's safety instructions.
and working.
© Wagner Spray Tech - All Rights Reserved
Publicité
