Télécharger Imprimer la page

WAGNER Home Decor Paint Sprayer Manuel Du Propriétaire page 8

Publicité

Les langues disponibles

Les langues disponibles

Cleaning the Filter:
IMPORTanT: Before every use, you should
inspect the air filter in the turbine to see if it
is excessively dirty. If it is dirty, follow these
steps to replace it.
IMPORTanT: never operate your unit
without the air filter. Dirt could be sucked in
and interfere with the function of the unit.
1. Remove the dirty filter from the turbine and
replace with new one. The smooth side of the
air filter must be placed toward the turbine.
PROBLEM
Problem a: Little or no
material flow
Problem B: Material
leaking
Problem C: Spray pattern
too thick, runs and sags
Problem D: Spray jet
pulsates
Problem E: Too much
overspray
Problem F: Pattern is very
light and splotchy
This unit contains no servicable
electrical parts. Do not attempt to
service yourself. Store indoors with
the cord wrapped around the turbine
handle.
English
8
All manuals and user guides at all-guides.com
Maintenance
Troubleshooting
CAUSE
1. Nozzle clogged.
2. Suction tube clogged.
3. Material flow setting too low.
4. Suction tube loose.
5. Air vent on suction tube blocked.
6. No pressure build up in container.
7. Air filter clogged.
8. Spray material too thick.
1. Nozzle loose.
2. Nozzle worn.
3. Nozzle seal missing or worn.
4. Material build-up on air cap and
nozzle
1. Material flow setting too high.
2. Applying too much material.
3. Nozzle clogged.
4. Air filter clogged.
5. Too little pressure build-up in
container.
6. Spray material too thick.
1. Material in container running out.
2. Air filter clogged.
3. Spray material too thick.
1. Gun too far from spray object.
1. Moving the spray gun too fast.
2. Material flow setting too low.
SOLUTION
1. Clean.
2. Clean.
3. Increase material flow setting.
4. Remove and replace as tightly
as possible.
5. Clean (see page 7)
6. Tighten container.
7. Change
8. Thin.
1. Tighten.
2. Replace.
3. Replace.
4. Clean.
1. Decrease material flow setting.
2. Adjust material flow or increase
movement of spray gun.
3. Clean.
4. Change.
5. Tighten container.
6. Thin.
1. Refill.
2. Change.
3. Thin.
1. Reduce distance (3"-6" is ideal).
1. Adjust material flow or de-
crease movement of spray gun.
2. Increase material flow setting.
Have you tried the recommendations
above and are still having problems? In
the United States, to speak to a customer
service representative, call our Technical
Service at 1-800-328-8251. See www.
wagnerspraytech.com in the "Contact Us"
section for Technical Service hours.
© Wagner Spray Tech - All Rights Reserved

Publicité

loading