Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
TECHNICAL DATA RECEIVER 702
Indication
Accuracy 2-step
Signal tones (can be switched off)
Display illumination
Power supply
OPERATIONAL ELEMENTS
1. Display
2. Vial
3. Accuracy coarse / fine
4. Loud speaker
5. Button ON/OFF
6. Sound ON/OFF
7 .
Illumination ON/OFF
8. Receiving window
9. Display
10. Thread for clamp
11. Battery case
12. Clamp
SYMBOLS
1. Receiver ON/OFF
2. Battery status indicator
3. Detection accuracy
4. Sound ON/OFF
5. Detected position indicator
16
www.geo-fennel-ecoline.com
2 x LCD
± 2mm, ± 1mm
3
yes
1 x 9V Alkaline
12
ACCURACY COARSE / FINE
The EL 702 is equipped with two accuracy modes. It can be chosen by
pressing button (3):
Accuracy coarse: ± 2 mm
Symbol on display:
Accuracy fine: ± 1 mm
Symbol on display:
INSTALLATION OF BATTERIES
Open the battery compartment cover (11). Insert 1 x 9 V AA battery (take
care of correct polarity!). Close cover. In order to save battery power the
receiver will automatically turn off if it has not received laser scanning sig-
nal for 5 minutes.
USE OF RECEIVER
Press button (5) to switch on.
Move receiver up and down carefully to detect the laser beam.
A.
Move the receiver down
Acoustic signal : ultra-short requent beep
Move the receiver up
B.
Acoustic signal: short requent beep
C.
On level
Acoustic signal: continuous beep
A+B: The closer the distance to „on level" (C) is,
the shorter the arrows become
CLAMP FOR LEVELLING STAFF
If required EL 702 can be attached to laser poles or any other equipment by
means of the clamp supplied with the kit.
EN
17
ECOLINE
Publicité
Table des Matières
