Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.4 Preset Position Setup
The Eyseo Pan / Tilt dome camera may call or store 16 Preset Positions. The purpose
of Preset Positions is to simplify user need for priority area monitoring and real-time
monitoring when necessary.
1.
Use the Remote Control to select and control the desired Eyseo Pan / Tilt Dome.
2.
Use the Remote Control to move to the desired position.
3.
Use the number buttons to enter the preset number, then press [SET PRESET]
button.
Example: To store Preset Position number 13, press button: [1] [3] and [SET PRESET].
6.5 Call Preset Position
When a Preset Position has been programmed it can be called by using the controller.
1.
Select and control the desired Eyseo Pan / Tilt dome camera.
2.
Use the number buttons to enter the preset number, then press [GO PRESET]
button.
Example: To call Preset Position number 13, press button: [1] [3] and [GO PRESET].
6.6 Preset Auto Pan
Once the auto pan function has been activated, the dome automatically recalls the pre-
programmed preset positions. To start a group press [1] – [6] and then [AUTOPAN].
Group 1:
Fast Pan Preceding 4 Preset Points.
Group 2:
Slow Pan Preceding 4 Preset Points.
Group 3:
Fast Pan Preceding 8 Preset Points.
Group 4:
Slow Pan Preceding 8 Preset Points.
Group 5:
Fast Pan 15 Preset Points.
Group 6:
Slow Pan 15 Preset Points.
To stop Auto Pan press [AUTO PAN] or any direction button.
6.7 Manual Control (Up / Down / Left / Right)
Use the direction buttons (Up / Down / Left / Right) of the Remote Control to control the
movement of the Eyseo Pan / Tilt dome camera.
Camera lens will rotate continuously when the button is pressed and unreleased.
26
Publicité
Chapitres
Table des Matières
