Publicité
Les langues disponibles
Les langues disponibles
CAUTION
Do not allow contact between the common and the fixture's chassis ground. Grounding the com-
mon can cause a ground loop, and your fixture may perform erratically. Test cables with an ohm
meter to check correct polarity and to make sure the pins are not grounded or shorted to the shield
or each other.
CONTROL PANEL
The control panel is the mechanism for configuring the settings. It has a small LCD screen and four
buttons, which are described hereafter.
Button Function
<MENU>: Scrolls through the first level of options, or exits from the current menu or function
<UP>: Navigates upward through the menu list or increases the numeric value when in a function
<DOWN>: Navigates downward through the menu list or decreases the numeric value when in a
function
<ENTER>: Enables the currently displayed menu or sets the currently selected value in to the cur-
rent function
MENU STRUCTURE
DMX address
Channel mode
DMX
(function mode)
Auto Run
Music control
Reset default
Signal Set
Reverse Pan
Reverse Tilt
SET
Select Pan
(Fixture setting)
Select Tilt
Mic sensitivity
OFF Signal Mode
Totem Mode
Reset
MANU
(Manual mode)
Channel
ADV (Advanced)
Calibration
(Access code
088)
MENU
A001 - A512
38CH / 26CH / 66CH
Program 1-9
Program 1-9
Yes/No
Wire
ON/OFF
ON/OFF
630°/540°/360°
270°/180°/90°
0-99%
ON/OFF
OFF/CEN./R/L
Total Reset
Scan Reset
Zoom Reset
PAN=XXX.......
PAN=XXX.......
www.afx-light.com
Description
DMX address
38 / 26 / 66 channel mode
Master/Alone Automatic mode
Master/Alone Sound-controlled mode
Reset to default values
Wired DMX
Reverse Pan
Reverse Tilt
Select Pan
Select Tilt
Mic sensitivity
OFF at original status; ON at Reset
status when there is no DMX signal
Totem mode
Total Reset
PAN/TILT Reset
Zoom Reset
Manual channel control
Calibration UID code
11
EN
Publicité
