afx light BEEDREAM760-FC Manuel D'utilisation page 10

Please contact the nearest authorized technical assistance center. Always use the same type of
spare parts.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• The lenses, housing or ultraviolet filter must be replaced if they are visibly damaged.
• The light source is not replaceable. It it is faulty, the product must be discarded.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
INSTALLATION
The unit should be mounted via its screw holes on the bracket.
Always ensure that the unit is firmly fixed to avoid vibration and
slipping while operating. Always ensure that the structure to which
you are attaching the unit is secure and is able to support a weight
of 10 times of the unit's weight.
The installation must always be secured with a secondary safety
attachment, e.g. an appropriate safety rope.
Never stand directly below the device when mounting, removing or
servicing the fixture.
DMX CONNECTION
Connect an XLR cable to the male 3-pin XLR output of your control-
ler and the other side to the female 3-pin XLR input of the light.You
can chain multiple lights together through serial linking
The cable needed should be two core, screened cable with XLR in-
put and output connectors.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female
XLR connector on the other end.
Termination reduces signal errors. To avoid signal transmission
problems and interference, it is always advisable to connect a DMX
signal terminator.
EN 10 © Copyright LOTRONIC 2023