Microlife BP B6 Connect Mode D'emploi page 8


If the measured systole and diastole differ in different direc-
tions from the stored average, this is indicated first with the
systole figure flashing, together with the up or down arrow
for two seconds. Thereafter, the diastole figure flashes with
the arrow pointing up or down for two seconds.
Appearance of the irregular heartbeat (IHB) symbol
This symbol BL indicates that an irregular heartbeat was detected.
In this case, the measured blood pressure may deviate from your
actual blood pressure values. It is recommended to repeat the
measurement.
Information for the doctor in case of repeated appearance of
the IHB symbol:
This device is an oscillometric blood pressure monitor that also
measures the pulse during blood pressure measurement and
indicates when the heart rate is irregular.
5. Data memory
This device automatically stores up to 99 measurement values for
each of the 2 users.
Select either user 1 or 2 by pressing the user button 5.
Viewing the average of the last 28 days
Press the M-button 3 again. The display first shows «M» BP and
«28A», which stands for the average measurement values of the
last 28 days.

Blood pressure readings with suboptimal cuff fit BT-A are
not considered in the average value.
Viewing the clinical blood pressure average «MyBP»
Pressing the M-button 3 briefly when the device is switched off,
allows you to see the average clinically relevant blood pressure
«MyBP». The display first shows «M» BP and «MyBP» BQ. This
average is only shown when 12 clinically relevant measurement
values in the last 28 days have been performed.

Only measurements that were performed in the morning
between 05:00-10:59 or in the evening between 17:00-
22:59 are considered.

A maximum of 4 readings per day are considered (2 from
the morning and 2 from the evening).
6

Measurements performed in standard mode and in MAM-
mode are considered in the average, when they have been
performed during the right time of the day.

Measurements performed in MAM-mode or single standard
mode are both classed as single measurements for working
out the «MyBP average».

Blood pressure readings with suboptimal cuff fit BT-A are
not considered in the average value.
Viewing the stored single values
Pressing the M-button again, allows you to see the last performed
measurement. The display first shows «M» BP and a value, e.g.
«M17». This means that there are 17 single values in the memory.
Pressing the M-button again displays the previous value. Pressing
the M-button repeatedly enables you to move from one stored
value to another.

Pay attention that the maximum memory capacity of
99 memories is not exceeded. When the 99 memory is
full, the oldest value is automatically overwritten with
the 100 value. Values should be evaluated by a doctor
before the memory capacity is reached – otherwise data
will be lost.
Clearing all values
Make sure the correct user is activated.
If you are sure that you want to permanently remove all stored
values, hold down the M-button (the device must have been
switched off beforehand) until «CL ALL» appears and then
release the button. To permanently clear the memory, press the
Blutetooth/Time button while «CL ALL» is flashing. Individual
values cannot be cleared.

Cancel deletion: press ON/OFF button 1 while «CL
ALL» is flashing.
6. Battery indicator and battery change
Low battery
When the batteries are approximately ¾ empty the battery symbol
AS will flash as soon as the device is switched on (partly filled
battery displayed). Although the device will continue to measure
reliably, you should obtain replacement batteries.