Publicité
Les langues disponibles
Les langues disponibles
Flat battery - replacement
When the batteries are flat, the battery symbol AS will flash as soon
as the device is switched on (flat battery displayed). You cannot
take any further measurements and must replace the batteries.
1. Open the battery compartment AK at the back of the device.
2. Replace the batteries – ensure correct polarity as shown by the
symbols in the compartment.
3. To set date and time, follow the procedure described in Section
«2. Using the device for the first time».
The memory retains all values although date and time must
be reset – the year number therefore flashes automatically
after the batteries are replaced.
Which batteries and which procedure?
Use 4 new, long-life 1.5 V, size AA alkaline batteries.
Do not use batteries beyond their date of expiry.
Remove batteries if the device is not going to be used for a
prolonged period.
Using rechargeable batteries
You can also operate this device using rechargeable batteries.
Only use «NiMH» type reusable batteries.
Batteries must be removed and recharged when the flat
battery symbol appears. They should not remain inside the
device as they may become damaged (total discharge as a
result of low use of the device, even when switched off).
Always remove the rechargeable batteries if you do not
intend to use the device for a week or more.
Batteries cannot be charged in the blood pressure monitor.
Recharge batteries in an external charger and observe the
information regarding charging, care and durability.
7. Using a mains adapter
You can operate this device using the Microlife mains adapter (DC
6V, 600 mA).
Only use the Microlife mains adapter available as an orig-
inal accessory appropriate for your supply voltage.
Ensure that neither the mains adapter nor the cable are
damaged.
Microlife BP B6 Connect
1. Plug the adapter cable into the mains adapter socket AT in the
blood pressure monitor.
2. Plug the adapter plug into the wall socket.
When the mains adapter is connected, no battery current is
consumed.
®
8. Bluetooth
Function
®
Use the Bluetooth
function to transfer data to «Microlife
Connected Health+» App on a smartphone (Android OS or iOS).
Information available on: www.microlife.com/technologies/
connect
®
Bluetooth
operations
Manually turn on Bluetooth
®
to activate Bluetooth
, Bluetooth
blink.
Automatically turn on Bluetooth
matically after a measurement. Bluetooth
display will blink.
Manually turn off Bluetooth
®
off Bluetooth
.
Automatically turn off Bluetooth
matically after 2 minutes if a smartphone does not connect to
the device.
®
Bluetooth
pairing & app setup
1. Open «Microlife Connected Health+» App on the smartphone
(Make sure the app is running in the foreground, not in the back-
ground.)
®
2. Turn on Bluetooth
manually to connect device to smartphone.
3. When smartphone finds the device, the smartphone will show a
message to pair with the device. Confirm on smartphone to
complete pairing. Cancel to abort pairing.
4. After pairing, the app will show a message to setup the device
user selection (1 or 2) to the app user profile. Confirm to
proceed with setup. Cancel to abort setup (if user selection is
incorrect).
5. After setup, the device will automatically exchange measure-
ment data and date/time settings with the app. Bluetooth
off automatically after data exchange.
®
: Press Bluetooth/Time button 4
®
symbol AO on display will
®
®
: Bluetooth
will activate auto-
®
symbol AO on
®
: Press ON/OFF button 1 to turn
®
®
: Bluetooth
will turn off auto-
®
turns
EN
7
Publicité
