Valor L1 Serie Instructions D'installation page 3

3. Position plinth in space between glass and trim,
locate ends onto end support. Ensure plinth is level
with trim.
Notes :
- The opening in the plinth should be oriented as
shown below to allow air to enter while obstructing
any view through the opening.
- Each end of the plinth has a rounded notch
opening to insert the tab of the side doors.
- The bottom edge of the trim is more or less visible
depending of the thickness of the wall fi nish under
the trim.
Trim directly on the fi nished cement board
Flange below plinth is
visible when the trim is on
thicker wall fi nish
Trim on 1" thick wall fi nish
All manuals and user guides at all-guides.com
Insert hinge
pin here
hinge
pin
Insert tab
here
Opening in
the plinth
Plinth
4. Identify left hand door and its orientation according
to the images below.
Left door
Front view Rear view
5. Locate hinge pin into upper hole.
6. Lower door hinge pin into the notch at the end of
the plinth.
hinge pin
7. Repeat for right hand door.
TOP of door:
this space is
wider
TOP of door:
tab at the rear
BOTTOM of door:
this space is
narrower
hinge
pin
Insert hinge
pin here
3