Installation Requirements; Tools And Parts - Haier HCH2400ACB Instructions D'installation Et Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

Gather the required tools and parts before starting installation. Read and follow the
instructions provided with any tools listed here.
TOOLS NEEDED
Level
Drill with 1¼", ¹⁄₈", and ⁵⁄₁₆" Drill Bits
Pencil
Wire Stripper or Utility Knife
Tape Measure or Ruler
Pliers
Caulking Gun
PARTS NEEDED
6" (15.2 cm) dia. round metal vent duct - length required is determined by ceiling
height.
For non-vented (recirculating) installations, you will also need:
Air Deflector - Order Part #31206014
Charcoal Filters (pkg. of 2) - Order Part #31264001
To purchase these parts for your range hood, contact the Haier Customer
Satisfaction Center at 1-877-337-3639.
PARTS SUPPLIED
Remove parts from packages. Check that all parts are included.
120 V Power Cord (with 3 prong plug)
Hood Canopy Assembly (blower, vent
transition, light bulbs [pre-installed])
Metal Grease Filter
Vent Cover Support Bracket
Caulking Compound (weatherproof)
Vent Clamps
Jigsaw or Keyhole Saw
Flat-blade Screwdriver
Metal Snips
Phillips Screwdriver
Metric Hex Key Set
Two-Piece (Upper and Lower) Vent
Cover
Mounting Screws
Washers
Drywall Anchors
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hch3400acb

Table des Matières