Installation Preparation; Preparing Hood Location - Haier 3000 Série Guide De L'utilisateur

installation Preparation

To install this range hood, you will need the following tools and materials:
note: this procedure will require 2 people for easier installation.
tools needed for installation
• Drill
• 1/8" Drill bit for drilling pilot holes
• 1-1/4" Wood bit for drilling electrical wiring access hole
• Phillips head screwdriver
• Flat-head screwdriver
• Pliers
• Pencil, ruler and level for marking range hood location
• Hand saw or jig saw for cutting the wall or cabinet openings
• Hi-Temp duct tape
• Electrical tape
• Connector Clamp

Preparing Hood Location

1. Determine whether hood will discharge vertically (3¼" x 10" or 7" Round),
horizontally (3¼" x 10" only) or non-ducted. For vertical or horizontal discharge,
run ductwork between the hood location and a roof cap or wall cap. For best
results, use a minimum number of transitions and elbows.
2. Use diagram, below, for proper placement of ductwork and electrical cutout in
cabinet or wall. For a non-ducted installation, DO NOT cut a duct access hole.
3. Run house wiring between service panel and hood location.
English
4