Installation Requirements; Tools And Parts - Haier HCH2100ACS Guide De L'utilisateur

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

Gather the required tools and parts before starting installation. Read and follow the
instructions provided with any tools listed here.
Tools needed
•
Level
•
Drill with 1¼", ¹⁄₈", and ⁵⁄₁₆" drill bits
•
Pencil
•
Wire stripper or utility knife
•
Tape measure or ruler
•
Pliers
For non-vented (recirculating) installations, you will also need:
•
6" (15.2 cm) dia. round metal vent duct - length required is determined by ceiling
height.
Parts supplied
Remove parts from packages. Check that all parts are included.
•
120 V power cord with 3 prong plug
•
Hood canopy assembly with blower,
vent transition, light bulb and
canopy glass already installed
•
Metal grease filter
•
Vent cover support bracket
•
Mounting template
•
Caulking gun and weatherproof
caulking compound
•
Vent clamps
•
Jigsaw or keyhole saw
•
Flat-blade screwdriver
•
Metal snips
•
Phillips screwdriver
•
Metric hex key set
•
2-piece vent cover
•
4 - 4 x 8 screws
•
6 - 5 x 45 mm mounting screws
•
2 - 8 x 40 mm wall anchors
•
4 - 10 x 50 mm wall anchors
5