Flex L 1710 FRA Notice D'instruction D'origine page 20

Attaching/changing the tool
Pull out the mains plug.

Attach the sanding disc
Remove the handle from the power

tool by rotating it in an anti-clockwise
direction.
Rotate the cover on the handle

by 180° until it engages (1.).
The stop key is released.

Fig. E
Press and hold down the spindle

lock (2.).
Using the stop key, loosen the clamping

nut on the spindle in an anti-clockwise
direction and remove (3.).
Insert the grinding wheel in the correct

position.
Screw the clamping nut with flange face

up, onto the spindle.
Fig. F
Press and hold down the spindle lock.

Tighten the clamping nut with the stop

key.
Carry out a test run to check that the tool

is clamped in the centre.
NOTE
In the case of L 1506 VR, loosen/tighten
the clamping nut with the enclosed face
spanner.
Attaching the Velcro pad
Remove the guard.

Press and hold down the spindle lock.

Using the stop key, loosen the clamping

nut on the spindle in an anti-clockwise
direction and remove.
Remove clamping flange.

Fig. G
Screw Velcro pad clockwise onto

the spindle and tighten hand-tight.
Attaching or changing sandpaper
Fig. H
Place the sandpaper in the centre

of the Velcro pad and press on.
Carry out a test run to check that the tool

is clamped in the centre.
20
Test run
Insert the mains plug into the socket.

Switch on the angle grinder with

the switch rocker (without engaging it)
and run the angle grinder for approx.
30 seconds. Check for imbalances
and vibrations.
Switch off the angle grinder.

Switching on and off
Brief operation without engaged switch
rocker
Fig. I
Push the switch rocker forwards and

hold in position.
To switch off the power tool, release

the switch rocker.
Continuous operation with engaged
switch rocker
Fig. J
Push the switch rocker forwards and

engage by pressing the front end.
Fig. K
To switch off the power tool, release

the switch rocker by pressing the rear
end.
NOTE
Following a power failure, the switched
on power tool does not restart.
Preselecting the speed
(L 3410 VR, LE 14–7 125 and L 1506 VR
only)
Fig. L
To set the operating speed, move
the dial to the required value.
NOTE
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.
Angle grinder