Monitor Wristband; Connecting To A Pc; Connecting To A Tv - VOLTCRAFT BS-250XWSD Mode D'emploi

14. moNIToR wRISTBANd

1. Unwrap the wristband, position and fasten it on
your arm.
2. Mount the detachable display on the metal
plate. Observe the correct orientation, as the
metal point on the display should fit into the
hole on the plate. Slide the display downwards
to lock it onto the wristband.

15. CoNNECTINg To A PC

1. Open the cover on the right side of the monitor.
2. Connect the mini USB plug to the matching socket and connect the USB-A plug to a free USB
interface on your computer.
3. The endoscope now functions as a card reader. This enables you to have data stored on the
microSD card to be read out to the PC.
4. Disconnect the connection first via the operating system, before disconnecting the physical USB
cable.

16. CoNNECTINg To A TV

1. First, set the video output format (see section "Settings").
2. Open the cover on the right side of the monitor.
3. Connect the video cable jack with the matching socket on the endoscope and connect the cinch
plug with the video input of the TV set.
4. This will make the image on the display go off, and the camera image will then be displayed on
the TV screen.
123326_v5_1112_02_m_cs6.indb 27
Connecting the display unit to a PC is also possible, if the display unit has been detached
from the endoscope. However, do not connect the endoscope base unit to a PC if you
have previously dismounted the display from the endoscope.
27
11/8/2012 2:37:17 PM