Quality Espresso FUTURMAT OTTIMA EVO Mode D'emploi page 19

Electrical
Check that all the electrical connection characteristics comply with the
•
connection
voltage, frequency and power indications described on the machine
specifications plate. The specifications plate is located on the chassis
underneath the drainage tray.
We consider that the machine has been correctly installed when it has
•
been connected using an all-pole magnetic circuit breaker appropriate
to the power of the machine, and with an RCD with a residual current
that does not exceed 30 mA.
The machine must be installed according to the current electrical regu-
•
lations of the place of installation. You must ensure that the electrical
installation is reliably grounded in accordance with the above-
mentioned regulations. Quality Espresso does not accept any respon-
sibility for any injuries caused by faulty installation or grounding con-
nection.
You must not use any type of extension cords or power strips to con-
•
nect the machine to the power supply. The power connection cable
should never be rolled up, but instead should be fully extended to pre-
vent possible overheating.
Handling
Any internal handling of the machine must be carried out by an author-
•
ised technical service.
Cleaning and preventive maintenance must be carried out according
•
to the frequency indicated for the machine or technical service.
The manufacturer does not accept any responsibility for any damage to
•
the machine as a result of failing to comply with the said obligations, or
any damage from incorrect or improper use of the machine.
All machine components, including the power cable, should only be
•
replaced with original spares. If the power cable is damaged, it must
be replaced by the manufacturer, their after-sales service or similar
qualified personnel to prevent any hazards.
Before carrying out any maintenance work, disconnect the machine
•
from the electrical supply either through the main switch or by discon-
necting the power cable.
hostelearte.com
Note: this device does not exceed 70 dB of sound pressure.
19
17
EN