Publicité
Page 6 of 20
4. Once the first two bolts have been loosely threaded in, insert the remaining 30mm bolts
(with washers) (ITEMS 4 & 7) into the remaining two positions, up through the rear
light unit bracket and into the threaded holes in the subframe.
5. The empty hole left by the OEM tail unit can be filled in using the original plastic pop clip
and the larger 19mm washer (ITEM 8) included in the kit, push the plastic pop clip
through the undertray then place the washer over the exposed end on the inside of the
bike (under the seat unit)
CHECK ALL FASTENERS ARE TORQUED TO THEIR REQUIRED SETTINGS AND LIGHTING OPERATION
IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT LOW DOWN ON THE LICENCE
PLATE MOUNT, THERE IS A POTENTIAL CHANCE THE LICENCE PLATE COULD HIT THE BACK WHEEL
UNDER HEAVY LOAD AND OVER LARGE BUMPS IN THE ROAD. IT IS YOUR RESPONSIBILITY TO CHECK
FOR THIS POSSIBILITY AND TAKE AVOIDING ACTION. FAILURE TO CHECK THIS COULD RESULT IN
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and
suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and
care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that
the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its
option either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified or
used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the
defect arises from accident or neglect. Other than identified above and subject to R&G not limiting its liability for causing death
and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts
paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect the Buyer's statutory rights.
Unit
Tel: +44 (0)
420 89007 Fax: +44 (0)
1
(Using the same anti-cross threading technique as before)
SERIOUS INJURY.
ISS 1 01/09/2023 (TB)
CONSUMER NOTICE
, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 87301 www.rg-racing.com Email: info@rg-racing.com
1
BEFORE RIDING
R&G
LP0362
Publicité
