Publicité
Page 5 of 20
Passenger seat unit
•
•
OEM number plate bracket
OEM indicators (to re-use with Tail Tidy)
•
Tail Tidy Assembly
Before assembling this product, ensure all the components within the box are correct
1. Once the OEM tail unit has been removed and disassembled, cover the indicator and
number plate light wires with heat shrink (ITEM 9) if required.
2. Fit the OEM rear light unit to the mounting bracket (ITEM 2) using the provided self
tapping screw and 5mm washer (ITEMS: 5 & 6) to the middle mounting bolt.
3. Then fit the OEM number plate light unit to the tail tidy bracket (ITEM 1) using the OEM
fasteners. Routing the wiring up and through the tail tidy bracket as shown in the
diagram on Page 4, securing it with one of the provided cable ties through the slots
circled in the diagram with the head of the cable tie on the underside of the tail tidy
bracket.
4. Fit the OEM indicators to the indicator mounts at the side of the tail tidy bracket using
the OEM fasteners and washers.
5. Once the OEM light units have been assembled with the R&G components, position the
two mounting brackets together as they would be on the bike and roughly route them
into a position where they won't be trapped/pinched when mounting to the bike, using
the remaining cable tie if required.
TAIL TIDY FITMENT:
1. Offer up the tail tidy assembly to the motorcycle, making sure the wires are pushed into
the open hole on the back end of the motorcycles where the rear light unit sits.
2. If possible connect the wiring to the OEM wiring harness before attaching the tail tidy
unit. Then check the operation of the rear lights, making sure the indicators are on the
correct side.
It is recommended that thread lock is used on the mounting bolts at this point
3. Once the wiring has been connected and the tail tidy is being held in position, pass the
50mm bolts with 6mm washers through the section of the tail tidy with the longer
spacers, then through the regulator rectifier unit and up into the threaded holes in the
subframe.
Take care not to cross thread the mounting bolts, if in doubt apply slight upward
pressure to the bolt while turning counter clockwise until a click is heard/felt, then
Unit
Tel: +44 (0)
420 89007 Fax: +44 (0)
1
by comparing the legend and diagrams.
, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 87301 www.rg-racing.com Email: info@rg-racing.com
1
begin tightening.
R&G
LP0362
Publicité
