Publicité
Les langues disponibles
Les langues disponibles
EN
1. The heater
system is
overheated.
Temperature Limit
thermostat is
'HEAT' switch
cutoff.
has been
flipped on,
2. Fan motor is
but there is
defective.
no airflow.
3. Fan blower is
balanced badly.
4. The "POWER"
and the "HEAT"
switches are not
turned on.
1. Loose wiring.
2. Bad heating
element.
Fan runs but
no heat is
3. Build up of dirt
coming out.
on the fans
4. Heater fan is
defective.
1. The battery is
not properly
installed.
2. Not pointing to
the right position.
The remote
control does
3. There is an
not work.
obstacle in front of
the machine.
4. Press the
remote control
buttons too
quickly.
Check the air inlet and outlet. Turn
off the power switch and unplug it.
Wait 10 minutes, and then turn the
heater on again.
Ask qualified technician for help.
Ask qualified technician for help.
Turn these two switches on.
Ask qualified technician for help.
Ask qualified technician for help.
clean all fans
Ask qualified technician for help.
Make sure the battery is properly
installed. Move the battery's
transparent insulating piece away
before using.
Aim the remote control at the
receiver.
Remove the obstacles. Items
between the remote control and
the remote-control receiver will
block the signal.
Don't press the remote-control
buttons too quickly. Give the unit
enough time to respond to your
commands.
28
Publicité
