Publicité
Les langues disponibles
Les langues disponibles
EN
1. Heater switches
is on, but Flame is
not on.
Heater is on.
but no flame
or low flame
2. Flame Adjusting
intensity.
knob is at low
setting.
3. Loose wiring.
1. Flame element
is not attached to
the motor.
Flame are
frozen
2. Rotation motor
is defective.
1. Flame element
Excessive
isn't seated
noise in the
properly
lower portion
of the
2. Motor is
heater.
defective.
1. Heater power
switch is off.
2. Heater system
is overheated.
Heater
system
doesn't work
3. Loose wiring.
4. The air inlet or
air outlet is blocked
completely.
Long-press the "DIMMER" button
for 6 seconds, the appliance will go
into sleep mode. All the lights off,
the heating function goes on.
Long-press for 6 seconds again,
the appliance will back to normal
mode.
Turn the knob to the maximum
setting.
Contact a qualified electrician to
check all wiring for loose
connections.
Ask qualified technician for help.
Ask qualified technician for help.
Ask qualified technician for help.
Ask qualified technician for help.
Turn the heater power switch to
the "ON" position.
Maybe the heater is covered or air
inlet or air outlet is blocked;
remove the clothes or the blockage
and turn off the power switch and
unplug it. Wait 10 minutes, and
then turn the heater on again.
Check all wiring for loose connections.
Contact a qualified electrician.
Leave adequate space around the
unit. Remove the blockage, on or
in front of the air outlet.
27
Publicité
