Télécharger Imprimer la page

Costway NP11112BK Mode D'emploi page 11

Gril portable au propane

Publicité

Les langues disponibles

Les langues disponibles

Step 6: Installing Battery in Ignitor
See Figure 14. (The AAA battery is not included)
1. Turn the ignitor cap counterclockwise and lift the cap from the
control panel.
2. Slide a AAA battery, negative (-) end first, into the ignitor. Be sure
spring is still in place inside the ignitor cap
3. Replace the ignitor cap.
Step 7: Connecting the LP Gas Cylinder to the
Regulator
See Figure 15.
1.Remove the cap from LP gas cylinder.
2.Hold the LP gas cylinder firmly and insert into the regulator.
3.Turn the cylinder clockwise, taking care not to cross thread the
connection. Do not use tools.
NOTE: The regulator will seal in the cylinder valve resulting in some
resistance. An additional one-half to three quarters turn is required
to complete the connection. If you cannot complete the connection,
disconnect and repeat the above two steps. If you still cannot
complete the connection, DO NOT use this regulator!
4.Inspect valve connections. Look for any damage or debris.
Remove any debris. Never attempt to use damaged or plugged
equipment. See your local LP Gas Dealer for repairs.
Step 8: Testing Valves and Regulator for Leaks
See Figure 16.
Connections on the valve were tested at the factory to ensure no
gas leaks were present. However, shipping and handling could
loosen connections. As a safety precaution:
1.Turn the control knob off.
NOTE: To lock the control knob in the off position, turn the control
knob to LOCK(
).
2.Make sure the LP cylinder is properly connected to the LP gas
cylinder valve.
If you hear a rushing sound, immediately remove the LP gas
cylinder. This sound means there is a major leak at the connection.
Correct the problem before proceeding.
20
3.Using a clean paint brush and a 50/50 mixture of mild soap and
water, brush soapy solution over all the connections and fittings on
the grill.
4."Growing" bubbles indicate a leak. Remove the LP gas cylinder
and recap the bottle.
NOTE: If leaks cannot be stopped, do not try to repair by yourself.
Please consult qualified technician.
Ignitor Cap
AAA Battery
Figure 14
Regulator
LP Gas
Cylinder
Figure 15
21

Publicité

loading