Publicité
Les langues disponibles
Les langues disponibles
WARNING:
If any parts are damaged or missing do not operate this grill until the
parts are replaced. Use of this product with damaged or missing
parts could result in serious personal injury.
CAUTION:
Some parts may contain sharp edges that may cause personal
injury. Wear protective gloves if necessary.
Step 1: Attaching the Wheels
See Figure 5-6.
1.With the grill out of the box and packaging removed, place the grill
right side up on flat surface.
2.Remove the hitch pin, screws, and washers from the axle.
3.Locate the holes in the stand legs.
4.Slide the axle through the square hole in the left stand leg and
then through the round hole in the right stand leg.
5.Install the hitch pin into the hole in the axle to secure it in place.
6.Lift the grill, slide one washer and wheel onto the axle.
7.Using a second washer and screw, secure the wheel to the stand.
Securely tighten screw.
8.Repeat this process to secure the other wheel.
Step 2: Attaching the Stand Front Handle
See Figure 7.
1.Locate the handle mounts on the firebox.
2.Remove the screws, lock washers, and washers from the handle
mounts.
3.Align holes in stand front handle with holes in mounts.
4.Install front handle using Phillips screws. Securely tighten screws.
14
Axle
Square Hole
Figure 5
Round Hole
Axle
Washer
Figure 6
Screw
Washer
Lock Washer
Stand Front
Handle
Figure 7
Hole
Hitch Pin
Washer
Screw
Mount
15
Publicité
