Publicité
Les langues disponibles
Les langues disponibles
Igniting the Grill
Using the Ignition System to Ignite the
Grill
The ignition system ignites the burner with a spark from
the igniter electrode. You generate the energy for the
spark by pushing the igniter button. You will hear the
igniter ticking. After preheating on high is complete,
you may adjust the burner control knob to your desired
setting for grilling.
1) Open the grill lid (A).
2) Check that the burner control knob is in the off
position. Check by pushing in and turning knob
clockwise (B).
3) Confirm that the cylinder is properly installed. Refer
to "Installing the LP Cylinder."
4) Push the burner control knob in and turn it
counterclockwise to the start/high
5) Push the red igniter button several times, so it clicks
each time (D).
6) Check that the burner is lit by looking through the
cooking grates. You should see a flame.
7) If the burner does not ignite, turn burner control
knob to the off
position and wait five minutes to
allow the gas to clear before attempting to light the
burner again.
Should the burner fail to ignite using the ignition
system, refer to the TROUBLESHOOTING section.
There you will find instructions on igniting the grill with
a match to help determine the exact problem.
To Extinguish Burners
1) Push the burner control knob in and then turn
clockwise all the way to the off
A
B
position (C).
C
position.
D
OPERATION
WARNING: Open lid during ignition.
m
WARNING: Do not lean over open grill while
m
igniting or cooking.
WARNING: If ignition does not occur within five
m
seconds, turn the burner control knob to the off
position. Wait five minutes to allow accumulated
gas to dissipate, and then repeat the lighting
procedure.
11
weber.com
Publicité
