Signature Kitchen Suite SKSSV3001S Guide D'installation page 6

Part 2 INSTALLATION REQUIREMENTS
INSTALLATION DRAWINGS
2
The first step of the installation is to measure the current cutout dimensions and compare them to the cutout
dimensions shown below. Little or no cabinet work may be necessary.
IMPORTANT NOTE
• The cabinet base platform must be able to support 190lbs (86kg). If the cabinet does not have a solid bottom,
two braces or runners must be installed level with the bottom of the cutout to support the weight of the oven.
Make sure the base is level and the front of the cabinet is square. If the cabinet base is not level, the oven racks
will tend to slide out when opening the door.
• If marks, blemishes or the cutout opening are visible above the installed oven, it may be necessary to add wood
shims under the runners and front trim until the marks or opening are covered.
• If the cabinet does not have a front frame and the sides are less than 3/4" (1.9 cm) thick, shim both sides
equally to establish the cutout width.
• The junction box must be flush with the rear wall of the cabinet as shown below.
• This oven is only approved to be installed under the specific models as labeled on this unit.
• Kitchen cabinets in contact with the oven must be heat resistant up to 194°F (90°C), and fronts of nearby units
up to at least 158°F (70°C).
• Do not remove the gliding racks from the base packing. Gliding racks are attached separately to the top and
bottom of the oven.
Product Dimensions
Dimensions are the same as the single built-in oven.
Cutout Dimensions
Gas or electric cooktops may be installed over this oven.
See cooktop installation instructions for cutout size.
See label on top of oven for approved cooktop models.
25" (635 mm)
Top and/or side fillers
may be necessary if
unit is positioned
between existing
cabinets. Be sure they
are attached securely
since, they will anchor
the oven in the cabinet.
(SKSSV3001S, FOR 30" SINGLE BUILT-IN OVEN UNDERCOUNTER)
240 V / 208 V
Junction box location 3"ø
hole required (Junction box
may be in adjacent cabinet)
29 1/8" (740 mm) Min.
29 3/16" (741.4 mm) Max.
28 1/2" (723.9 mm) Min.
28 5/8" (727 mm) Max.
Cabinet
- 6 -
CAUTION
• DO NOT block the oven air exhaust
located at the bottom of the oven.
− Blocking the exhaust may cause cabinet
damage and product malfunction.
Gas and electrical connections for
30" (762 mm) gas cooktop must be located
in an adjacent accessible location to the
right. For a 36" (914 mm) gas cooktop, the
connections may be made to the left.
5"
Allow 11/16" (17 mm)
overlap top of oven,
23 1/2" (596.9 mm)
1 1/16" (17 mm) overlap
from the cutout
side edges of cutout
base
36" (914 mm)
Typical
Countertop
Height
24" (610 mm)
2 3/4"(70 mm) ~ 4"(102 mm)