Télécharger Imprimer la page

Signature Kitchen Suite SKSSV3001S Guide D'installation page 16

Masquer les pouces Voir aussi pour SKSSV3001S:

Publicité

Les langues disponibles

Les langues disponibles

Part 4
INSTALL THE OVEN
CABINET INSTALLATION
1
Install the oven into the cabinet as follows :
1. Sliding the oven into the opening.
a. Loop (do not tie) a 36" (91 cm) string around the conduit before the oven is slid into place. Lay the string
over the top of the oven and use it to keep the conduit from falling behind the oven.
b. Lift oven into cabinet cutout using the oven opening as a grip. Carefully push against the oven front frame.
Do not push against outside edges.
c. While sliding the oven back, pull the string so that the conduit lies on the top of the oven in a natural loop.
d. When you are sure the conduit is out of the way, slide the oven 3/4 of the way back into the opening.
Remove the string by pulling on one end of the loop.
CAUTION
• DO NOT block the oven air exhaust
located at the bottom of the oven.
− Blocking the exhaust may cause cabinet
damage and product malfunction.
2. Securing the oven.
a. Using the mounting holes on the oven side trim
as a guide, drill pilot holes for screws provided
(For securing the double wall oven, use a
minimum of 4 screws, one on each side in both
the upper and lower ovens. For securing the
single wall oven, use a minimum of 2 screws,
one on each side. For securing the Combi Oven,
use a minimum of 4 screws, one on each side in
both the upper and lower ovens.)
b. Secure the oven to the cabinet with screws
provided.
If the cabinet is particle board, you must use 3/4"
particle board screws. These may be purchased
at any hardware store.
3. Reinstall the oven door.
WARNING
• Mounting screws must be used.
− Failure to do so can result in the oven falling
out of the cabinet causing serious injury.
- Ensure that the metal bottom
trim is correctly installed.
- When you install the oven door,
be carefull not to bump the
metal bottom trim.
- Keep oven vents unobstructed.
Replace the bottom trim if it
becomes bent or deformed.
Never block the vent with plastic
or heat-sensitive items.
Mounting
Hole
Locations
Mounting
Hole
Locations
- 16 -
Metal bottom
trim (Vent)
Side Trim
Trim Screws
Side Trim
Metal
Lower base
bottom
trim
Metal Trim:
Correct
position
1 4/9"
(1.1 cm)
Metal Trim:
Wrong position

Publicité

loading

Ce manuel est également adapté pour:

Sksdv3002sSkscv3002s