Horizon Global 25006 Instructions D'utilisation page 5

1A. Remove Under Body Panels: To remove the driver side under body panel, remove 5
push pins using a flat head screwdriver and remove 1 plastic nut using a 15mm socket (using
a little force pull downward on the trim panel to help remove the plastic nut)
2. Remove Taillights: (Typical Both Sides) Remove the access panel inside the trunk. Inside
the access hole remove 2 nuts (4 total) using a 10mm socket. Unclip the wire harness from
inside the access hole. Slide the taillight rearward to remove.
© 2023 Horizon Global™ Corp. - Printed in Mexico
1B. Remove Under Body Panels: To remove the center trim panel, remove 4 push pins
using a flat head screwdriver and remove 1 plastic nuts using a 15mm socket (using a little
force pull downward on the trim panel to help remove the plastic nut) and 2 10mm nuts with
a 12mm socket
3A. Remove the Fascia: (Typical Both Sides) Remove 3 screws with a Philips Head
Screwdriver from the wheel well (6 total). Remove 1 bolt with an 8mm socket from the
wheel well (2 total). Remove 1 screw (2 total) and 1 push pin (2 total) by the taillight.
Remove 2 bumper bolts (M8 or M10, 4 total) from the forward side of the rear bulkhead.
(Bumper is attached to the fascia)
Sheet 5 of 27 25006NP 03-02-23 Rev. A