Speaker Connection; Installing The Microphone - Sony WX-XB100BT Mode D'emploi

Subwoofer Easy Connection
You can use a subwoofer without a power amplifier
when it is connected to a rear speaker lead.
Notes
 Preparation of the rear speaker leads is required.
 Use a subwoofer with an impedance of 4 Ω to 8 Ω,
and with adequate power handling capacities to
avoid damage.
Memory hold connection
When the yellow power supply lead is connected,
power will always be supplied to the memory
circuit even when the ignition switch is turned off.

Speaker connection

 Before connecting the speakers, turn the unit off.
 Use speakers with an impedance of 4 Ω to 8 Ω,
and with adequate power handling capacities to
avoid damage.
Power connection diagram
Check your car's auxiliary power connector, and
match the connections of leads correctly
depending on the car.
Auxiliary power connector
Common connection
Red
Yellow
continuous power
12
supply
15 switched power supply
32
GB
Front speaker
Subwoofer
Red
Yellow
Yellow
Red
When the positions of the red and yellow
leads are inverted
Red
Yellow
12 switched power supply
continuous power
15
supply
When the car without ACC position
Red
Yellow
After matching the connections and switching
power supply leads correctly, connect the unit to
the car's power supply. If you have any questions
and problems connecting your unit that are not
covered in this manual, consult the car dealer.

Installing the microphone

To capture your voice during handsfree calling, you
need to install the microphone .

Clip (not supplied)
Red
Yellow
Yellow
Red
Red
Yellow

