Messages - Sony WX-XB100BT Mode D'emploi

The sound skips during playback of a
BLUETOOTH audio device.
 Reduce the distance between the unit and the
BLUETOOTH audio device.
 If the BLUETOOTH audio device is stored in a case
which interrupts the signal, remove the audio
device from the case during use.
 Several BLUETOOTH devices or other devices
which emit radio waves are in use nearby.
 Turn off the other devices.
 Increase the distance from the other devices.
 The playback sound stops momentarily when the
connection between this unit and the cellular
phone is being made. This is not a malfunction.
The connected BLUETOOTH audio device cannot
be controlled.
 Check that the connected BLUETOOTH audio
device supports AVRCP.
Some functions do not work.
 Check if the connecting device supports the
functions in question.
A call is answered unintentionally.
 The connecting phone is set to answer a call
automatically.
Pairing failed due to a timeout.
 Depending on the connecting device, the time
limit for pairing may be short.
 Try completing the pairing within the time.
BLUETOOTH function cannot operate.
 Turn off the unit by pressing OFF for more than 2
seconds, then turn the unit on again.
No sound is output from the car speakers during
handsfree call.
 If the sound is output from the cellular phone, set
the cellular phone to output the sound from the
car speakers.
Siri Eyes Free is not activated.
 Perform the handsfree registration for an iPhone
that supports Siri Eyes Free.
 Set the Siri function on the iPhone to on.
 Cancel the BLUETOOTH connection with the
iPhone and the unit, and reconnect.
Sony | Music Center operation
Application name is mismatched with the actual
application in "Sony | Music Center".
 Launch the application again from the "Sony |
Music Center" application.
26
GB
While running the "Sony | Music Center"
application via BLUETOOTH, the display
automatically switches to [BT AUDIO].
 The "Sony | Music Center" application or
BLUETOOTH function has failed.
 Run the application again.
The "Sony | Music Center" application is
automatically disconnected when the display
switches to [IPOD].
 The "Sony | Music Center" application on iPhone/
iPod does not support iPod playback.
 Change the source of the unit to other than
[IPOD], then establish the "Sony | Music
Center" connection (page 14).
The "Sony | Music Center" connection is
automatically disconnected when the USB mode
of the unit is changed to [ANDROID].
 The Android smartphone is not supporting
playback in Android mode.
 Set the USB mode of the unit to [MSC/MTP],
then establish the "Sony | Music Center"
connection (page 14).

Messages

The following messages may appear or flash during
operation.
AUDIO OUTPUT ERROR: There may be an internal
malfunction.
 Check the connection. If the error message still
remains on in the display, consult your nearest
Sony dealer.
INVALID
 The selected operation could be invalid.
OVER TEMPERATURE CAUTION: The thermal
protector is activated.
 Reduce the volume.
READ: Now reading information.
 Wait until reading is complete and playback
starts automatically. This may take some time
depending on the file organization.
(underscore): The character cannot be
displayed.
For CD playback:
CD ERROR: The disc cannot be played. The disc will
be ejected automatically.
 Clean or insert the disc correctly, or make sure the
disc is not blank or defective.