Blaupunkt 5HC1110 Serie Notice D'utilisation page 38

Detaching and attaching the oven door
For cleaning purposes and to remove the door panels, you can
detach the oven door.
The oven door hinges each have a locking lever. When the
locking levers are closed (figure A), the oven door is secured in
place. It cannot be detached. When the locking levers are open
in order to detach the oven door (Fig. B), the hinges are locked.
They cannot snap shut.
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Ensure that the locking levers are always fully closed or,
when detaching the oven door, fully open.
Detaching the door
Open the oven door fully.
1.
Fold up the two locking levers on the left and right (figure A).
2.
Close the oven door as far as the limit stop. With both hands,
3.
grip the door on the left and right-hand sides. Close the door
a little further and pull it out (figure B).
Attaching the door
Reattach the oven door in the reverse sequence to removal.
When attaching the oven door, ensure that both hinges are
1.
inserted straight into the opening (figure A).
The notch on the hinge must engage on both sides (figure B).
2.
38
Fold back both locking levers (figure C). Close the oven
3.
door.
:
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the after­sales service.
Removing and refitting the door panels
The glass panels can be removed from the oven door to allow
more thorough cleaning.
Removal
Removing the oven door See the section Removing the oven
1.
door. Lay the oven door on a cloth with the handle facing
downwards.
Remove the cover from the top of the oven door. To do this,
2.
press with your fingers on the left and right-hand side. Pull
out the cover (Fig. A).
Raise the top panel and pull it out (Fig. B).
3.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Fitting
Hold the top glass panel firmly by the sides and slide it in
1.
towards the back at an angle. The panel must be inserted
into the openings on the lower side. The smooth surface must
face outwards, while the roughened side must be on the
inside. (Fig. A).