Steinbach Poolrunner Battery Pro Performance Notice Originale page 25

6
6
1. Press the ON/OFF switch
The status indicator
2. Hold the device by the handle and lower it slowly into the water until all the air has escaped.
3. Then let the device sink to the bottom of the pool.
Make sure that the device lands on the bottom of the pool on its underside and that cleaning can
start without obstruction towards the center of the pool.
The status indicator
The device is in the pool and starts cleaning with a time delay.
Configuring the cleaning program via the app
You must pair the device with the app and configure the cleaning program while the device is out of the
water before placing the device in the pool and starting cleaning. Any settings you have made are saved
and applied in future operation.
1. Activate Bluetooth.
If you use an Android device, you might have to activate GPS as well.
2. Press the ON/OFF switch
The status indicator
3. Press the ON/OFF switch a second time (within max. 2 seconds).
The status indicator
4. Start the "Battery Pro Line" app.
5. Search for available devices.
6. Select your device to connect it to the app.
The app signals the successfully established connection. The status indicator
device is connected to the app.
7. Follow the instructions of the app and select the desired parameters.
8. Check and confirm the set values.
9. Press the ON/OFF switch
The status indicator
The cleaning program has been configured and saved.
Switching off the device
Proceed as follows to switch off the device:
1. Lift the device out of the pool and switch it off.
2. Clean the filter unit and the device.
5
.
6
is lit blue. The device is switched on and ready for operation.
5
blinks blue.
5
.
6
is lit blue. The device is ready for operation.
5
blinks pink. The device is ready to connect to the app via Bluetooth.
5
to switch it off.
6
is lit red and goes off as soon as the device has switched itself off.
5
7
is lit pink. The
5
25