Construction And Function; Construction - Balluff BTL5-P/I/L/M1-M Série Notice D'utilisation

BTL5-P/I/L/M1-M _ _ _ _ -H/W(8) -S32/KA _ _ /K _ _
Magnetostrictive Linear Position Sensor – Rod Style
3

Construction and function

0.5 Ø 25
BTL5...-S32
Ø 5 for hook spanner Ø 65,
max. tightening torque
100 Nm
~12
1) Unusable area
2) Not included in scope of delivery
BTL5...-KA _ _
~20
Fig. 3-1: BTL5-...-H/W(8)-..., construction and function
3.1

Construction

Electrical connection: The electrical connection is made
via a cable or a connector (see Type code on page 17).
Housing: Housing containing the processing electronics.
Mounting thread: We recommend assembling the BTL
on the mounting thread:
– BTL5-...-H: M18×1.5
– BTL5-...-W: 3/4"-16UNF
The BTLs with Ø 10.2 mm have an additional thread at the
end of the rod to support larger nominal lengths.
Magnet: Defines the position to be measured on the
waveguide. Magnets are available in various models and
must be ordered separately (see Accessories on
page 15).
6 english
H: 40 -1mm
W: 2"-0.04"
Nominal length =
1) Measuring range
Magnet 2)
Thread
H: M18×1.5
W: 3/4"-16UNF
Mounting surface
25
43
Ø 65
0.5 Ø 25
43
Damping zone 1)
60
Version D1
...-H/W-... 10.2 mm
...-H8/W8-... 8 mm
BTL5...-K_ _
35
0.5 Ø 25
21
Nominal length: Defines the available measuring range.
Rods with various nominal stroke lengths from 25 mm to
5500 mm are available depending on the version of the
BTL:
– Ø 10.2 mm: Nominal length from 25 mm to 5500 mm
– Ø 8 mm: Nominal length from 25 mm to 1016 mm
Damping zone: Area at the end of the rod that cannot be
used for measurements, but which may be passed over.
Ø 65
G
G
Thread
M4x4/6 deep
No thread
Ø 65