Publicité
CONTROL PANEL
1. Install the batteries as instructed in "Battery Installation and Battery
Safety" on Page 5.
2. The weight reading will change according to the weight on the
Electronic Scale. It may include the weight of the provided Food
Tray.
3. To subtract the weight of the provided Food Tray or any food con-
tainer in use, press the Weight Reset Button. The display will read
"0g" or "0.00 oz".
4. The thickness reading will change according to the position of the
Adjustment Plate. Turn the Thickness Adjustment Knob to the
desired thickness.
5. To set the thickness display to "0", turn the Thickness Adjustment
Knob counterclockwise to move the Adjustment Plate to the mini-
mum thickness. Press the Thickness-Reset Button to set the display
to "0".
6. The thickness display may not show "0" when the adjustment plate
is returned to minimum position because of the tolerance of the
gears. Press the Thickness-Reset Button to read "0" again.
7. The display on the Control Panel will automatically turn off after 15
minutes of being idle, i.e., the weight or thickness has not been
changed for 15 minutes.
OPERATING THE FOOD SLICER
CAUTION: Blade is sharp. Handle carefully.
1. Place the Food Slicer on a hard, flat and level work surface. The
Electronic Scale will not operate properly if the work surface is not
level.
2. Plug the Food Slicer into a 120VAC, 60Hz,
10A outlet.
3. Before turning ON, ensure that the Blade is
installed correctly and not touching any-
thing.
4. To turn on the appliance, first push the
Safety Switch from position "O" to "I" then
without releasing the Safety Switch, press
down on the Pulse Switch. KEEP HANDS
AWAY FROM BLADE! See Figure 3.
5. To turn off the appliance, release the Pulse switch. The Pulse Switch
will spring up and the Safety Switch will return to the "O" position
automatically. The Blade will stop in seconds.
Instructions for Use
Pulse
Switch
10
Safety
Switch
Figure 3
Publicité
