Publicité
Les langues disponibles
Les langues disponibles
Do not overstress your tool.
Of course, you will only achieve optimal work results within the
performance range for which the machine is designed! There-
fore, avoid making the infeed too large! Do not misuse the
machine, and do not use it for work for which it is not intended.
Always be prudent and attentive!
Observe the machine during work and proceed sensibly. Do not
use the machine if you are distracted, tired, or if you have con-
sumed alcohol.
Handle the connecting cable with care!
Protect the connecting cable from heat and sharp edges, and
lay the cable so that it cannot be damaged. Do not pull on the
cable to disconnect the plug from the socket outlet, and do not
lift the device by the cable. Ensure cleanliness: Protect the
cable from grease and oil!
Clean thoroughly after work!
Disconnect the mains plug!
Always unplug the mains plug when not in use, before mainte-
nance, when changing tools, cleaning or repairing! Removing
the chips is also a part of cleaning!
Carefully read the operating instructions before use and keep
them in a safe place!
Contents
Foreword
Safety guidelines
Legend
Description of the machine
Technical data
Installation and setting up
Operating the handwheels
Switching on the automatic feed
Working with the tailstock
Selecting the turning tool
Inserting the cutting tool in the tool post
Setting the spindle speeds
Calculating the maximum spindle speed
Clamping the work piece in the lathe chuck
Exchanging the clamping jaws
Switching on the machine
Longitudinal turning
Face turning
Taper turning
Cutting off a work piece
Machining long work pieces with tailstock and centre
Fitting change gears for thread cutting
Thread cutting with the turning tool
Thread cutting using the top slide
Cutting left threads
All manuals and user guides at all-guides.com
Accessories for Lathe PD 250/E
Repair and Maintenance
EC Declaration of Conformity
Spare parts list
Legend (Fig.1)
Page
16
16
17
18
10. Handwheel for leadscrew
18
11. Clamp screw for tailstock
18
12. Leadscrew
18
13. Adjusting handwheel for top slide
19
14. Top slide
19
15. Support
19
16. Cross-slide
19
17. Adjusting handwheel for cross-slide
20
18. Clutch switch for automatic feed
20
19. Drive gearbox cover with speed table
20
20. Switch for anticlockwise rotation - stop - clockwise
20
21. Main switch
20
22. Function display
21
23. Control
21
24 Hollow hexagon wrench
21
25. Lathe chuck wrench
21
26. Chuck guard
21
22
22
23
23
Installing the centre lathe
Removing the centre
Four-jaw chuck
Collet chuck unit and collet chucks
Fastening the drill chuck
Fixed steady
Cleaning
Adjusting the play of the guides
Adjusting the play of the handwheels
1. Main spindle
2. Lathe chuck
3. Turning tool holder
4. Rotating centre
5. Flange surface for milling unit
6. Sleeve
7. Clamp screw for sleeve
8. Tailstock
9. Sleeve adjusting handwheel
rotation
23
23
23
23
23
24
24
24
24
24
24
25
126
- 17 -
Publicité
