Side sealing strips
Loosen the fastening screws of the
sealing strip.
Replace the sealing strip.
Screw on new sealing strip without fully
tightening it.
To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.
Adjust sealing strip.
Tighten the fastening of the sealing
strip.
Replacing dust filter
Warning
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
Lock parking brake.
Remove the waste container.
Remove the securing splint of the vibra-
tor bar.
Pull out the bar.
Unscrew locking screws.
Remove the tin frame.
Replace the dust filter.
Note: Make sure when installing the new
filter that the fins are not damaged.
22
Accessories
Side brushes
6.905-626.0
With standard bristles for indoor and out-
door areas.
Side-brushes, soft
6.906-132.0
For fine dust on inside surfaces; wetness
resistant.
Hard side-brushes
6.905-625.0
For removing stubborn dirt in the external
area; resistant to moisture.
Classic model
Standard sweep roller 6.906-509.0
Resistant of wear and moisture. Universal
bristles for inside and outside cleaning.
Comfort model
Roller brush, pro
6.906-508.0
For professional applications, especially
safe against wear and tear.
Dust filter
5.731-585.0
Replace the flat-fold filter at least once a
year. Resistant to moisture, washable Fil-
ter effect > 99,9%, corresponds to catego-
ry C of ZH 1/487 of BIA.
9
-
EN