Publicité
Danger
Risk of burns! With all work in this area, you
must make sure that the exhaust pipe is
cooled off.
Adjust sweeping track width, Com-
fort model
Note: If the sweeping track is too small and
the Bowden cable is tensioned when the
roller brush is lowered, the Bowden cable
must be adjusted.
Adjust sweeping track on Bowden cable.
Check sweeping mirror.
Adjust sweeping track width, Classic
model
1 Rotary knob
Turn the rotary knob:
– In clock-wise direction: Sweeping track
becomes smaller
– Anti-clockwise direction: Sweeping
track becomes bigger
Check sweeping mirror.
Replacing side brush
Replacement is due if a visible deteriora-
tion in sweeping performance caused by
bristle wear is evident.
Note: If the appliance is tilted backwards
onto the push handle, the fuel tank must not
be filled more than halfway.
Comfort model: Rotate push handle
clock in an anti-clockwise direction.
Lock has been unlocked.
Close fuel cock.
Remove the waste container.
Push appliance to the back onto the
push handle.
Unscrew 3 screws from the underside
of the side brush.
Remove the wiper blade.
Clip new side brushes on to driver and
screw on.
Tilt the appliance forward.
Adjust side-brush lowering
Adjustment is necessary if a visible deterio-
ration in sweeping performance caused by
side-brush is evident.
Loosen counter-nut.
Adjust the adjustment screw.
Tighten the counter-nut.
Adjust the raising of the bulk waste flap
– Adjustment is necessary if the bulk
waste flap cannot be raised wide
enough.
– The Bowden cable needs to be re-
leased a little if the sweeper results be-
come poorer, for e.g. due to the wearing
of the front lip.
Loosen counter-nut.
Adjust the adjustment screw.
Tighten the counter-nut.
Adjusting and replacing sealing strips
If the sweeping results degrade due to the
wear of the sealing strips, the sealing strips
must be readjusted or replaced.
Note: If the appliance is tilted backwards
onto the push handle, the fuel tank must not
be filled more than halfway.
Comfort model: Rotate push handle
clock in an anti-clockwise direction.
Lock has been unlocked.
Close fuel cock.
Remove the waste container.
Push appliance to the back onto the
push handle.
8
-
EN
Front sealing strip
Loosen the fastening screws of the
sealing strip.
Readjust the sealing strips pushing
them downward into the slot.
Tighten the fastening screws of the
sealing strip.
Prepare the appliance and move it a
small distance forwards.
Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 10 and 15 mm.
Note: If the setting range is not sufficient,
the sealing strip is worn off and should be
replaced.
Rear sealing strip
Remove the waste container.
Loosen the fastening screws of the
sealing strip.
Replace the sealing strip.
Tighten the fastening of the sealing
strip.
21
Publicité
