Inserting The Sim Card; Language Settings - Minox DTC 1000 Mode D'emploi

the DTC 1000 (see also "Format" under "Camera
Setting"). This procedure deletes older data from
the SD card and prepares your card for an error-free
operation in your camera. It is recommended to
record some images directly after inserting the SD
card to verify the camera's functionality.
Please make sure that the camera is turned off be-
fore inserting or removing the SD card. Switch your
DTC 1000 to SET (12) to continue with your camera
settings.

Inserting the SIM Card

To send photos with your DTC 1000, you will need
an activated SIM card from a mobile phone provider
of choice. You can use a prepaid card or a phone
plan card. Make sure that the card used for the DTC
1000 is activated to send MMS messages. It is also
important that this card is not locked with a PIN.
Note: MINOX assumes no responsibility for any
costs that may arise in connection with the use of
mobile telephone networks.
Insert the SIM card into the correct slot (10) with the
chip towards the front of the camera. A schematic
imprint of the proper card position is indicated next
to the card slot.
Note: Please make the sure the camera is turned
off before inserting or removing the card.

Language Settings

The DTC 1000 Trail Camera is set to English by factory
default. To change the menu navigation to a different
language, please follow these steps:
1. Push the main switch (12) to SET.
2. You are now in Manual Release mode.
3. Push MENU (15) once. You are now in the main
menu of the camera.
3. Push the UP arrow button (11) twice.
4. You are now in the "Language" menu.
5. Push OK (11) once.
6. Using the UP/DOWN arrow buttons (11), select the
desired language.
7. Push OK (11) once.
8. The main menu is now in the language you have
chosen.
51