Access Control; Power Type - Minox DTC 1000 Mode D'emploi

Access Control

Here you can set a 4-digit PIN to prevent unauthor-
ized access to the files on your camera. Without a
correct PIN, it is not possible to enter the main menu
after turning the camera on.
Go to the main menu and select "Camera Setting"
and then push OK (11). Using the UP/DOWN arrow
buttons (11), select "Access Control" and then verify
with OK (11). In the sub-menu, you can set the fol-
lowing preferences:
Set Password
Push the UP/DOWN arrow buttons (11) to choose
the desired number (0-9) and the RIGHT and LEFT
arrow buttons (11) to change positions. When you
are finished, verify your setting by pushing OK (11).
You will automatically enter the "Password" menu.
You can make further settings or push the LEFT arrow
button (11) to enter the previous menu.
Disable Password
Go to the main menu and select "Camera Setting"
and then push OK (11). Using the UP/DOWN arrow
buttons (11), select "Access Control" and then verify
with OK (11). In the sub-menu, choose "Disable Pass-
58
word" and push OK (11). You will automatically enter
the "Camera Setting" menu. You can make further
settings or push the LEFT arrow button (11) to enter
the previous menu.

Power Type

Your DTC 1000 Trail Camera is a high-tech precision
device. It is highly suggested to use high-quality
alkaline, Lithium-Ion or NiMH batteries. To set the
correct type of batteries you will be using, go to the
main menu and select "Camera Setting" and then
push OK (11). Using the UP/DOWN arrow buttons
(11), select "Power Type" and then verify with OK
(11). Choose the power source or battery type you
will be using with the UP/DOWN arrow buttons (11)
and verify with OK (11).
Note: If you will use Li-Ion batteries, please select
"Lithium or Alkaline". Alternative to batteries, an
external power supply of 6V or 9V can be used.
If the camera is connected to an external power
supply, the batteries will be bypassed – it is not
possible to recharge the batteries while in the cam-
era. Please do not use a 12V power supply as this
will damage the camera and nullify the warranty.