Jennair JBZFR24IGX Guide D'utilisation Et D'entretien page 13

Once installed, tap the JennAir
app. You will be guided through the steps to set up a user
account. The App will make sure to get the necessary
personal and home information as well as information
about your energy company.
4.
Register your refrigerator in your user account
Registering your refrigerator in your account is a
necessary step in order for you to take full advantage of
the Smart features. When prompted by the app, enter
the SAID (case-sensitive), which can be found on a sticker
on the inside of the water filter door.
My Smart Appliance ID# is:
The Wi-Fi status indicator on the refrigerator control
panel will blink slowly while your refrigerator and router
attempt to connect.
NOTE: This blinking only applies to first-time registration
after provisioning. Blinking will not occur for automatic
reconnection after a connection is established.
Once you've connected your refrigerator to your
home Wi-Fi network, it will remain linked even if the
power goes out, you move the appliance, or if you put
it in storage.
If you replace your wireless router or get a different
Smart appliance, you will need to repeat this
connectivity set-up process.
MANUAL SETUP (FIRST-TIME USE)
— ACCESS POINT METHOD
This procedure uses Micro Access Point technology and is
applicable if your router does not support WPS.
1.
Before starting the Setup procedure, please take
note of the home wireless network name (SSID), its
password and the SAID of appliance. These will be
required during the installation process.
2.
Turn on your router and make sure the internet
connection is working.
3.
On your appliance, activate the provisioning process
using the AP method. You should see the Wi-Fi icon
blinking on the appliance HMI.
4.
Turn on your smart device (phone or tablet) and
access your list of available wireless networks in the
settings menu.
5.
The appliance has created a wireless network (SSID).
Select this network from the list of available wireless
networks. The network name is made up of the prefix
from your appliance type (e.g. washer, dryer, etc.)
followed by the MAC address
App icon to open the
®
(ex. REFRID_88_E7_12_B3_66_ C3). If you don't see it,
you may need to refresh the list of networks or verify
the Wi-Fi icon is on the appliance display.
6.
Once you have selected the SSID, a password will be
required. Use the SAID as a password
(i.e., 444441ABCD).
NOTE: This password is case-sensitive.
7.
Connect to the network.
8.
Wait until your device is confirmed to be connected
to the appliance Wi-Fi network.
9.
Open a web browser. If nothing appears, type
"192.168.10.1" in the address bar (URL) and press
Enter. The browser displays a Smart web page. It is
the configuration page of the Wi-Fi radio of your
appliance.
10.
In the drop-down list of available networks, select the
name of your home wireless network.
11.
If your home wireless network is hidden, select
"Other" and manually enter its name (SSID) and
security protocol.
WPA2
12.
Enter the password for your home wireless network, if
required, and submit. Remember, this kind of
password is case-sensitive.
13.
Click the " " button to submit, and wait a few
seconds.
14.
The Wi-Fi icon on the appliance should stop blinking
and turn on permanently once connected. Otherwise,
disconnect and reconnect the appliance to the main
power and repeat the procedure.
15.
The Setup process is complete.
13