Jennair JBZFR24IGX Guide D'utilisation Et D'entretien page 17

VACATION CARE
1.
Remove all food from the refrigerator/freezer.
2.
Empty the ice bin.
3.
Turn the power switch to Off.
A. To access the power switch, remove the
by pulling out to release it from the brackets.
B. To replace, press the toekick panel onto the
toekick bracket to engage the gripping pads.
4.
Clean refrigerator/freezer, wipe it, and dry well.
5.
Tape rubber or wood blocks to the tops of both doors
to prop them open far enough for air to get in. This
stops odor and mold from building up.
POWER INTERRUPTIONS
If the power will be out for 24 hours or less, keep the door
closed to help food stay cold and frozen.
If the power will be out for more than 24 hours, do one of
the following:
Remove all frozen food and store it in a frozen food
locker.
Place 2 lbs (907 g) of dry ice in the freezer for every
cubic foot (28 L) of freezer space. This will keep the
food frozen for 2 to 4 days.
If neither a food locker nor dry ice is available,
consume or can perishable food at once.
REMEMBER: A full freezer stays cold longer than a
partially filled one. A freezer full of meat stays cold longer
than a freezer full of baked goods. If you see that food
contains ice crystals, it may be refrozen, although the
quality and flavor may be affected. If the condition of the
food is poor, dispose of it.
REPLACING THE WATER FILTER
The water filter should be replaced every 6 months based
on a flow rate of 0.75 gpm-0.80 gpm (1.89- 2.27 Lpm) that
filters 200 gallons (757 L) of water.
NOTE: If the filter is not installed correctly, water may
dispense at a lower flow rate and there will be slower ice
production. Improper filter installation may also cause
the water filter housing to leak.
1.
To open, push the water filter door up, which is
located at the upper left above the refrigerator or
freezer compartment.
2.
Turn the water filter 90° counterclockwise to unlock.
toekick
3.
Pull the filter out of the housing.
4.
Remove the water filter cap from the water filter.
5.
Install the water filter cap onto the new filter. Be sure
to align the arrows so the grooves in the filter align
with ribs in the filter cap.
17