Technical Data; Cleaning And Maintenance - Royal Catering RCGV-1400 Manuel D'utilisation

The operation manual must be reviewed.
Never dispose of electrical equipment together
with household waste.
This machine conforms to the CE declarations.
Attention! Hot surface may cause burns.
For indoor use only.
PLEASE NOTE! Drawings in this manual are for
illustration purposes only and in some details it may
differ from the actual machine.
The original operation manual is in German. Other
language versions are translations from German.
USER MANUAL
SAFETY INSTRUCTIONS
General safety information for the use of electrical devices
To avoid injury from fire or electric shock, please ensure
the compliance with the safety instructions when using this
device. Please read the instructions carefully and make sure
that you have understood them well. Keep the manual near
the equipment to be able to read it at any time. Always use
current sources which are connected to the ground and
which provide the necessary voltage (this info is indicated
on the label on the device). If you have any doubts, let an
electrician check that your outlet is properly grounded.
Never use a damaged power cable. Do not open the unit
in damp or wet environment, or if your hands or body are
damped or wet. Protect the unit from solar radiation. Use
the device in a protected location to avoid damaging the
equipment or endangering others. Make sure the device is
able to cool and avoid placing it too close to other devices
that produce heat. Before cleaning the device, disconnect it
from the power source. Use a soft damp cloth for cleaning.
Avoid using detergents and make sure that no liquid enters
the unit. No internal element of this device needs to be
maintained by the user. Opening the device without our
approval leads to a loss of warranty!
SAFETY GUIDELINES
1. L1. Please read and understand these instructions
carefully before operating the device! Please observe
the safety guidelines carefully in order to prevent
damages through improper use!
2. Please keep this manual available for future
reference. If this device is passed on to third parties,
the manual must be passed on with it.
3. Only use this device indoors and for its intended use.
4. We do not offer any warranty for damages resulting
from improper use or incorrect operation.
5. Before the first use, check whether the main voltage
type and current comply with the indicated data on
the type plate.
6. This device is not intended to be used by persons
(including children) with limited physical, sensory or
mental aptitude, as well as lack of experience and/or
knowledge, unless they are supervised by a person
responsible for their safety or if they have received
instructions as to how the device is used.
7. ELECTRIC SHOCK HAZARD! Do not attempt to repair
the unit yourself. In case of device failures, repairs
must be done by qualified experts.
6
U S E R M A N U A L
8. Please check the main plug and the power cable
regularly. If the power cable for this device is
damaged, it has to be replaced by the manufacturer
or its customer service or another qualified person in
order to prevent hazards.
9. Prevent damages to the power cable by avoiding
squeezing or bending it or rubbing it on sharp
edges. Also keep the power cable away from hot
surfaces and open flames.
10. ATTENTION! DANGER TO LIFE! While cleaning, never
immerse the device in water or other liquids.
11. Under no circumstances should the housing be
opened.
12. When using the device, never touch the heating
plate or its enclosure, as they constitute a scalding
hazard.

TECHNICAL DATA

Product name Vertical Grill
Model RCGV- RCGV- RCGV-
1400 1800 1800-1
Rated voltage [V] 230V~
Frequency [Hz] 50
Rated power [W] 1500 1800 1800
Timer range (timer) 0 – 60 0 – 90 0 – 90
[min]
Working capacity[l] 10 17 17
Weight [kg] 4,2 5,2 5,2
SCOPE OF APPLICATION
The vertical grill is designed for grilling meat, fish and
vegetables.
The user is liable for any damage resulting from
nonintended use of the device.
BEFORE THE FIRST USE
Upon receipt of the goods, check the packaging for integrity
and open it. If the packaging is damaged, please contact
your transport company and distributor within 3 days, and
document the damages as detailed as possible. Do not turn
the package upside down! When transporting the package,
please ensure that it is kept horizontal and stable.
DISPOSAL OF THE PACKAGING
Please keep all packaging materials (cardboard, plastic tapes
and Styrofoam), so that in case of a problem, the device can
be sent back to the service centre in accurate condition!
INSTALLING THE APPLIANCE
APPLIANCE LOCATION
The temperature of the environment must not exceed 45°C
and the relative humidity should not exceed 85%. Ensure
good ventilation in the room in which the device is used. The
distance between the back of the chain toaster and the wall
should be at least 20 cm, a minimum distance between the
sides of the device and the walls should be at least 10 cm on
each side and 35 cm between the top of the device and the
ceiling. Keep the device away from hot surfaces. Operate the
device on flat, stable, clean, refractory and dry surfaces out
of the reach of children and people with mental disabilities.
Rev. 06.12.2017
Install the device making sure that constant access to the
main plug is ensured. The power cord connected to the
appliance must be properly grounded and correspond to
the technical details. Before the first use, remove all elements
and clean them along with the entire device!
PRINCIPLE OF OPERATION
A
E
J
I
C
H
D
K
L
B
M
F G
A. upper housing
B. base
C. heating elements
D. door handle
E. glass door
F. timer
G. in-use control light
H. spit
I. skewer
J. top attachment
K. bottom attachment
L. drip tray
M. on/off switch (HALF POWER; FULL POWER)
Set the required power using the switch, the in-use light
will come on and the skewer will begin rotating. Use timer
to set the required time – this will activate the heating
elements. Once the time on the timer has elapsed, the
heating elements will automatically switch off. The skewer
will continue rotating until it is switched off using the on/
off switch.
ATTENTION! Do not place items on top of the device!
ATTENTION! When in use, some device elements heat up to
very high temperatures – there is a risk of burning! Do not
touch these elements with bare hands! Use tongs or other
kitchen utensils to remove ready food.
ATTENTION! Before first use, turn the device on to HALF
POWER and set the timer to twenty minutes (without
loading food). Some smoke may be emitted by the device
– this is normal.
ASSEMBLY/DISASSEMBLY OF THE DEVICE'S ELEMENTS
Spit prongs installation
1
2
Rev. 06.12.2017
1. top of skewer (ends with a notch)
2. bottom of skewer
Prongs may be attached to the spit. Ensure the fastening
screw is tight. Load meat, vegetables etc. onto the spit then
attach the other prongs (slide them flush with the loaded
food) then use screw to fasten prongs securely in place. Then
insert the spit into the grill: first insert its lower part into the
opening at the bottom of the grill and then slide the upper
section onto the top grill attachment. To take the spit out,
first remove the top section from the grill and then take it
out of the device. Loosen the screw on one of the prongs
then slide the food off the spit.
Mounting grill skewers:
Attach a round end piece to the spit and secure with a screw,
attach a second round end piece on the other end of the
spit and also screw tight. Attach skewers loaded with food
using the eye to the top end piece and insert skewer point
into the bottom end piece. Insert the spit with end pieces
into the device.
Assembling grilling plates:
Slide plates onto the spit and attach to the spit using screws
at the required heights. Place fish or other foodstuffs onto
the plates and insert into the device.
TRANSPORTATION AND STORAGE
During transport, the machine should be protected from
shaking, crashing and turning upside down. Store it in
a properly ventilated place with dry air and without any
corrosive gas.

CLEANING AND MAINTENANCE

• Always unplug the device before cleaning the
equipment. Disconnect the device from the electricity
when it is not in use. Let the device cool down before
cleaning it.
• Use only cleaner without corrosive substances to
clean the surface.
• Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
• Never clean the device with a pressurized water-jet.
• Use warm water and mild detergent to wash the door
and glass part of the housing.
• Use warm water with mild detergent and a soft cloth
to wash the metal housing and the interior of the
device. After washing wipe dry.
• Elements such as: spits, skewers, prongs, plates, drip
trays etc. are dishwasher safe, or use warm water with
a mild detergent (make sure screws are removed from
particular elements.
7