Publicité
Les langues disponibles
Les langues disponibles
INSATALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
TOOLS NEEDED
• Flat-blade Screwdriver
• Phillips Screwdriver
LOCATION REQUIREMENTS
Place the air conditioner on a flat, level surface in a location that
is at least 19.7inches(50cm) from any wall.
NOTE: A minimum clearance of 19.7inches(50cm) from the air
conditioner to the wall must be maintained to ensure proper
airflow.
Maintain a minimum 19.7inches(50cm) clearance around the air
conditioner to not block airflow.
Keep the air conditioner free of any obstructions such as drapes,
curtains, blinds, etc.
The exhaust hose should be free of any obstructions.
Do not place the air conditioner on an unstable or raised surface
because it could fall and cause damage or injury.
Do not place the air conditioner in direct sunlight or near a heat
source such as baseboard heaters, stoves, etc.
The window panel can be installed in a window with a minimum
19.7inches(50cm) to a maximum 40.2inches(102cm) opening.
14
ELECTRICAL REQUIREMENTS
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power
cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or
electrical shock.
POWER SUPPLY CORD
Wiring Requirements
• 115 Volt, 60Hz, 15-amp fused grounded 3 prong outlet
• The use of a time-delay fuse or time-delay circuit breaker is
recommended.
• Use a dedicated circuit only.
15
Publicité
