Publicité
Les langues disponibles
Les langues disponibles
All cylinders to be used are designated for the recovered
refrigerant and labelled for that refrigerant (i.e. special cylinders
for the recovery of refrigerant). Cylinders shall be complete with
pressure relief valve and associated shut-off valves in good
working order. Empty recovery cylinders are evacuated and, if
possible, cooled before recovery occurs. The recovery equipment
shall be in good working order with a set of instructions
concerning the equipment that is at hand and shall be suitable for
the recovery of flammable refrigerants. In addition, a set of
calibrated weighing scales shall be available and in good working
order. Hoses shall be complete with leak-free disconnect
couplings and in good condition. Before using the recovery
machine, check that it is in satisfactory working order, has been
properly maintained and that any associated electrical
components are sealed to prevent ignition in the event of a
refrigerant release. Consult manufacturer if in doubt.
The recovered refrigerant shall be put in the correct recovery
cylinder, and the relevant Waste Transfer Note should be
arranged. Do not mix refrigerants in recovery units and especially
not in cylinders. If compressors or compressor oils are to be
removed, ensure that they have been evacuated to an acceptable
level to make certain that flammable refrigerant does not remain
within the lubricant. The evacuation process of compressor shall
be carried out. Only electric heating to the compressor body shall
be employed to accelerate this process. When oil is drained from
a system, it shall be carried out safely.
12
PARTS AND FEATURES
1. Control Panel
2. Air Outlet
3. Caster
4. Air Intake
5. Filter
6. Fastener
7. Air Intake
8. Handle
9. Plug Storage Area
10. Power Cord Cover
11.Drain Port
12.Power Supply
13.Drain Cover and Plug
14.Remote Control
15.Connector
16.Exhaust Hose
17.Adapter
18.Window Kits
19.Window Kits Screw
(butterfly nut)
13
Publicité
