Publicité
Les langues disponibles
Les langues disponibles
Care and Maintenance
WARNING
Be sure to turn off the unit and pull out the plug before maintain.
Surface cleaning
- Unplug the appliance before cleaning.
- Clean the unit surface with wet soft cloth and do not use
chemical solvents such as alcohol and gasoline to avoid any
damage to unit. Any thinner, alcohol-glazer or other similar
solvents is prohibited for unit cleaning.
- Clean the dirty air outlet or louvers with wet soft cloth and
detergent. Any chemical solvent is prohibited to use for unit
cleaning or put such things near the unit for a long time.
Filter cleaning
- Clean the filter once every two weeks, or it would influence the
unit function if filter clogged with dust.
- Grip the filter handle and pull it out gently in correct direction.
Clean the dirty particles in filter by cleaner if it is necessary.
Immerse and wash the filter gently into warm water (about 104°F /
40°C) mixed with neutral cleaner, and then rinse and dry it
thoroughly in the shade.
Notes:
- Pull out the filter gently.
- Removal of filter at back panel is at priority then for the filter at
side panel, to avoid any twist or damage to filter.
- Do not squash or hit the mesh with sharp objects or brush.
30
- Do not use the appliance without installing the filter.
INTERNAL WATER TANK
The Water Full indicator illuminates, when the internal water has
filled with condensate water.
To Empty the Internal Water Tank:
1. Unplug or disconnect power.
2. Place a shallow 1 quart or larger pan (not included) below the
lower drain located on the back (near the bottom) of the air
conditioner.
3. Remove the cap and the rubber plug and drain the water tank.
4. Re-insert the drain plug and screw the cap snugly into place.
5. Plug in or reconnect power.
Storage
Please store the air conditioner properly if not in use.
1. Screw off the drain cover and pull out the stopper to drain
condensate water completely. Or tilt the unit to drain water.
2. Keep unit running in fan mode for half day to dry inside of unit
completely to prevent from going moldy.
3. Turn off the unit, pull out plug then wrap the power cord around
the wire-winding pillar, insert the plug into the universal fixing hole
at the back panel of the unit, install the water stopper and drain
cover.
4. Remove the heat exhaust hose to assembly, clean and keep it
properly.
5. Take out the batteries from remote controller and place it in the
remote control box.
31
Publicité
