Costway FP10233 Mode D'emploi page 15

● Make the unit in the upright position whatever handling or
moving it.
● Drain the water in the unit completely to prevent water leakage
and wet the floor or carpet before handling or moving the unit.
DRAIN THE INTERNAL WATER
You will need a small pan to catch the water coming out of the
water tank. Once the water tank is empty, the unit will resume
operation within a few minutes.
Manual drainage
1. Once the unit shuts down upon water-full, turn off the unit and
then unplug.
2. Put the tray below the water outlet at the back of the unit.
3. Screw off the drain cover, unplug the water stopper for water
flow into the tray.
4. Plug in stopper and screw the drain cover tightly onto water
outlet after drainage.
Notes:
● Protect the drain cover and water stopper properly.
● Move the unit carefully to avoid the leakage it is necessary.
● Tilt the unit slightly backwards when draining.
● Block the drain hole as soon as possible before the tray is full if
it cannot hold all water in the unit to prevent the water leakage
and wet the floor or carpet.
28
● Water stopper and drain
cover must be tightly
installed, to avoid new
condensate to wet the floor
or carpet when the unit
re-starts working.
Continuous drainage
1. Screw off the drain-cover & unplug the water stopper.
2. Connect drain-hole with φ13mm drain hose ((If you need the
plastic drainage pipe, please purchase it with outer diameter
13mm and length according to the drainage distance), as deep as
possible to avoid leakage.
3. Pull the drain hose to bathroom or outdoor.
Notes:
● Drain hose must be installed when there's no water in the tray.
● It is suggested that not to use continuous drainage when unit is
in COOL mode, to ensure enough water recycle in the unit to
enhance the system cooling effects.
● Put the drain hose in an inaccessible place, not higher than
drainage hole and keep drain hose straight without any flexure.
● Keep the drain cover and its
stopper properly when
continuous drainage is
adopted.
29