Publicité
- 90 -
R – Slew Rate Commands
:RC# Set Slew rate to Centering rate (2
slowest)
nd
Returns: Nothing
:RG# Set Slew rate to Guiding Rate (slowest)
Returns: Nothing
:RM# Set Slew rate to Find Rate (2
Fastest)
nd
Returns: Nothing
:RS# Set Slew rate to max (fastest)
Returns: Nothing
:RADD.D#
Set RA/Azimuth Slew rate to DD.D degrees per second [Autostar II Only]
Returns: Nothing
:REDD.D#
Set Dec/Elevation Slew rate to DD.D degrees per second [ Autostar II only]
Returns: Nothing
Meade Telescope Protocol
- 13 -
:RgSS.S#
Set guide rate to +/- SS.S to arc seconds per second. This rate is added to or subtracted from the current tracking
Rates when the CCD guider or handbox guider buttons are pressed when the guide rate is selected. Rate shall not
exceed
sidereal speed (approx 15.0417"/sec)[ Autostar II only]
Returns: Nothing
S – Telescope Set Commands
:SasDD*MM#
Set target object altitude to sDD*MM# or sDD*MM'SS# [LX 16", Autostar, Autostar II]
Returns:
1 Object within slew range
0 Object out of slew range
:SbsMM.M#
Set Brighter limit to the ASCII decimal magnitude string. SMM.M
Returns:
0 - Valid
1 – invalid number
:SBn# Set Baud Rate n, where n is an ASCII digit (1..9) with the following interpertation
1 56.7K
2 38.4K
3 28.8K
4 19.2K
5 14.4K
6 9600
7 4800
8 2400
9 1200
Returns:
1 At the current baud rate and then changes to the new rate for further communication
:SCMM/DD/YY#
Change Handbox Date to MM/DD/YY
Returns: <D><string>
D = '0' if the date is invalid. The string is the null string.
D = '1' for valid dates and the string is "Updating Planetary Data# #"
Note: For Autostar II this is the UTC data!
:SdsDD*MM#
Set target object declination to sDD*MM or sDD*MM:SS depending on the current precision setting
Returns:
1 - Dec Accepted
0 – Dec invalid
:SEsDD*MM#
Sets target object to the specificed selenographic latitude on the Moon.
Returns 1- If moon is up and coordinates are accepted.
0 – If the coordinates are invalid
Publicité
