Initial Operation; Change Illuminant - brennenstuhl Power Jet-Light 4 x 36 W IP 54 Mode D'emploi

Power Jet-Light 4 x 36 W IP 54
6.1

Initial Operation

Step Activity
1 Plug the standing bracket on to the retaining bracket. Bolt the U-Bolt structure with the
U-Bolts.
2
13
Fasten the lamp body in the middle of the U-bolt structure. For this purpose use the bolt
spacer and the adjusting screw. The light bracket can be set through the adjusting screw.
IMPORTANT: Before the initial operation, check all the bolted connections.
3 Press the ON / OFF switch. The work lamp will be switched on or off accordingly.
6.2

Change illuminant

DANGER:
Pull the mains plug before opening the work lamp!
Let the work lamp cool before touching it (at least 15 minutes).
Coming into contact can lead to burns.
Step Activity
1 Set the work lamp on its „back". Press the rubber lip upwards.
2 Screw out the 4 protective covering bolts from the protective cover. Remove the protective
cover.
Operating Manual
6
23
22
16
3
3
11
2
Pos. Name
6 Standing bracket (U-Bolt structure)
9 Adjusting screw
16 Bolt spacer
13 Casing (Lamp body)
22 Washer
9
23 Lock washer
Pos. Name
3 Protective cover
11 Rubber lip
11
13 Casing (Lamp body)
13
Pos. Name
3 Protective cover
11 Rubber lip
2 Protective cover bolt
17 Status: 7201S-07-2007_K