Description Of Operation - brennenstuhl L CN 110 PIR IP44 Mode D'emploi

Operating Instructions
D
3. Mark the position of the bore-holes that are needed to attach the
wall bracket and drill the required holes in the wall. Attach the
bracket to the wall using suitable screws.
4. Open the light's terminal box.
5. Guide the connecting cable through the cable gland and
connect it to the light's lustre terminal as shown in Fig. 2
(left image shows model
L CN 110 PIR IP44, L CN 110 C PIR IP44, L CN 120 PIR IP44,
L CN 120 C PIR IP44, L CN 130 PIR IP44, L CN 150 PIR IP44,
right image shows model
L CN 110 IP65, L CN 120 IP65, L CN 120 C IP65,
L CN 130 IP65, L CN 150 IP65, L CN 180 IP65.
N = blue cable, earthing symbol = green / yellow cable,
L = brown cable).
6. Make sure the cable is securely fastened in the cable gland.
7. Replace the cover of the terminal box.
Make sure the gasket is seated correctly.
8. Set the light to the desired position and tighten the screws.

DEsCrIpTION OF OpEraTION

(For versions with a Motion Detector)
The light is equipped with an infrared sensor. It turns on automatically
whenever the sensor detects movement in its vicinity
Try not to aim the motion detector in the direction of swimming
pools, heater vents, air conditioners or objects which are subject to
large variations in temperature. Avoid pointing the motion detector
at trees or shrubs and at areas where pets like to move about.
Make sure when mounting the light that the motion detector is most
sensitive to things that move through its detection range from side
to side and least sensitive to things that move straight at the device.
10
A_Chip_Leuchte_Stationaer_0472362_1507.indd 10
Chip LED Light
09.07.15 09:50