Publicité
Les langues disponibles
Les langues disponibles
Power Jet-Light 4 x 36 W IP 54
-
Regularly check the work lamp for damages.
-
The work lamp must be separated from the mains voltage in order for it to be replaced. Pull the
connector from the socket.
-
Repairs should be carried out only by authorized personnel.
-
Let the work lamp cool down before touching it (for example during replacement of the illuminant).
-
Observe a minimum distance of 50 cm on each side to combustible materials.
-
Damaged cable line cannot be replaced. The work lamp is to be disposed appropriately.
-
Never switch multiple shockproof sockets one after the other.
-
Note the secure status of the work lamp.
4
Device overview
Below is a brief overview of the control panel and display of the device and a short functional description.
11
10
9
8
Pos.
Name
1
Retaining bracket
2
Protective shield bolts
3
Protective shied
4
Illuminant
5
Socket
6
Standing bracket
Operating Manual
7
Pos.
Name
7
Connector
8
Supply wiring
9
Adjusting screw (Quick release fastener)
10
Stirrup bolt
11
Rubber lip
15
1
2
3
4
5
6
Status: 7201S-07-2007_K
Publicité
Chapitres
